Oracle Solaris Os Configuration Parameters - Sun Oracle SPARC T4-4 Installation Manual

Solaris OS is running. See
page 49
during initial configuration.
9. Log in to the server and explore its capabilities.
There are many commands you can use to verify the functionality of the server.
The following list describes a few of them:
■
■
■
Review the Oracle Solaris OS man pages and documentation for more details.
Oracle Solaris OS Configuration
Parameters
This topic describes configuration parameters you must provide during initial Oracle
Solaris OS configuration.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network
Interfaces
DHCP?
Host Name
IP Address
Subnet?
Subnet Netmask
for a description of the Oracle Solaris OS parameters you must provide
showrev – Displays the host name and server architecture information. Use the
-a option with this command to see the patches that are installed.
psrinfo – Displays information about the number and status of the processors
and cores in the host.
prtdiag – Displays server configuration and diagnostic information.
Description
Select a number from the displayed language list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure, select
the first one in the list.
Select Yes or No according to your network environment.
Type the host name for the server.
Type the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
(If subnet was Yes) Type the netmask for the subnet for your network environment.
"Oracle Solaris OS Configuration Parameters" on
Powering On the Server for the First Time 49