Sun Oracle SPARC T4-4 Installation Manual page 56

Note – To enable first-time login and access to Oracle ILOM, a default Administrator
account and its password are provided with the system. To build a secure
environment, you must change the default password (changeme) for the default
Administrator account (root) after your initial login to Oracle ILOM. If this default
Administrator account has been changed, contact your system administrator for an
Oracle ILOM user account with Administrator privileges.
For more information about the administration tasks such as changing passwords,
adding accounts, and setting account privileges, refer to the Oracle ILOM
documentation.
Note – By default, the SP is configured to use DHCP to obtain an IP address. If you
plan to assign a static IP address to the SP,
MGT Port" on page 52
5. Open a second terminal device and log in to the SP as root.
After a brief delay, the SP prompt is displayed (->). At this point, there are many
commands you can perform using the ILOM interface.
6. In the first terminal device, redirect the host output to display on the serial
terminal device:
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started. To stop, type #.
. . .
After you start the SP console, the server initialization takes approximately 20
minutes to complete. This terminal device displays all SP console messages during
intial boot.
7. In the second terminal device, power on the server:
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
This terminal device displays all system console messages during initial boot.
8. When prompted, follow the onscreen instructions for configuring the Oracle
Solaris Operating System on your host and enter the following configuration
information.
You will be prompted to confirm the configuration several times, enabling
confirmation and changes. If you are not sure how to respond to a particular
value, you can accept the default, and make future changes when the Oracle
48 SPARC T4-4 Server Installation Guide • May 2014
see"Assign a Static IP Address to the NET
for more instructions.