Sun Oracle SPARC T4-4 Installation Manual page 61

In this procedure, you connect to the SER MGT port to manually reconfigure the NET
MGT port to use a static IP address.
Note – For more information on configuring ILOM, refer to the SPARC T4-4 Server
Installation Guide.
1. Set these network parameters according to the specific details of your network
configuration.
Parameter
/SP/network state
/SP/network pendingipaddress
/SP/network pendingipgateway
/SP/network pendingipnetmask
/SP/network pindingipdiscovery
/SP/network commitpending
Configure these parameters using the set command. For example:
-> set /host/network pendingaddress=xxx.xxx.xxx.xxx
Set 'pendingaddress' to 'xxx.xxx.xxx.xxx'
2. Configure the service processor using information from your network
administrator.
Parameter Description
Set up the network connection with a dynamically created IP
dhcp
configuration.
Set up the network connection with a static IP configuration.
static
a. If you choose to use a dynamically created IP address (use DHCP to retrieve
the network setting), set pendingipdiscovery to dhcp.
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
Description
Specifies whether or not the service processor
is on the network.
IP address of the service processor.
IP address of the gateway for the subnet.
Netmask for the service processor subnet.
Specifies whether the service processor uses
DHCP or static IP address assignment.
Commits the service processor to use the
pending settings
Powering On the Server for the First Time 53