2. Install the four screws that secure the power supply cage to the chassis.
3. Connect the cables from the power supply cage to the system board and all internal components (see
"System-board internal connectors" on page 118 for the locations of the internal connectors).
4. Reinstall both hot-swap power supplies (see "Installing a hot-swap power supply" on page 179).
5. Go to "Completing the FRU replacement" on page 190.
Replacing a hot-swap power supply
This procedure applies only to server models that have hot-swap power supplies.
When you remove or install a hot-swap power supply, observe the following precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
Removing a hot-swap power supply
To remove a hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
178
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Hardware Maintenance Manual