5. Align the flash device with the connector on the system board and push it into the connector until it
is firmly seated.
6. Press down on the retaining latch to lock the flash device into the USB connector.
7. Go to "Completing the FRU replacement" on page 190.
Replacing the virtual media key
Use the following procedures to replace the virtual media key.
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page 1.
2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the side
cover (see "Removing the side cover" on page 130).
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
1
Mounting bracket (feet)
2
Mounting tab
3
Virtual media key connector
4
Virtual media key (front)
4. If you are instructed to return the virtual media key, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
162
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Hardware Maintenance Manual