Table of Contents
Advertisement
5. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the
outside of the server. Then, remove the DIMM from the package.
6. Turn the DIMM so that the DIMM keys align correctly with the connector.
7. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of
the DIMM connector (see "System-board internal connectors" on page 118 for the location of the
DIMM connectors).
8. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the
DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly
inserted; open the retaining clips, remove the DIMM, and then reinsert it.
9. Go to "Completing the FRU replacement" on page 190.
Chapter 6. Replacing FRUs
139
Advertisement
Table of Contents
