Table of Contents
Advertisement
Removing the rear system fan
To remove the rear system fan, complete the following steps:
1. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
2. Unlock and remove the side cover (see "Removing the side cover" on page 130).
3. Remove any adapters that impede access to the fan and the fan connector on the system board (see
"Replacing an adapter" on page 152).
4. Disconnect the fan cable from the system board.
5. Grasp the fan 2 with both hands and pull firmly, extending the rubber grommets 1 . The
grommets will be pulled through the holes in either the fan or the chassis and can then be removed.
6. Pull the fan up and out of the chassis.
7. If you are instructed to return the fan, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Installing the rear system fan
To install the rear system fan, complete the following steps:
1. The replacement fan comes with the rubber grommets installed 1 ; however, they might have come
out during shipment. If any of the rubber grommets are missing from the fan, install them on the fan
before you continue. Use needle-nosed pliers to pull the grommets through the holes in the fan.
2. Position the fan 2 so that the grommets protrude through the holes in the chassis; then, use
needle-nosed pliers to pull the grommets through the holes from outside the chassis.
164
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Hardware Maintenance Manual
Advertisement
Table of Contents
