Table of Contents
Advertisement
Cleaning the Exterior Surfaces
When the exterior surfaces of the machine are stained,
dampen a soft cloth with water or a neutral detergent
diluted with water, squeeze it, and wipe the surfaces
with the cloth.
Cleaning the Platen
The platen easily gets dirty with lint, paper dust, etc.
generated when a media is cut.
Wipe off conspicuous stains with a soft-hair brush, a dry
cloth, a paper towel, etc.
• When the platen is stained with ink, wipe it off with a paper towel containing a small amount of
cleaning solution for maintenance.
• Before cleaning the platen, make sure that the platen has cooled adequately.
• Because dust and dirt are easily accumulated in the slots for holding a media and cutting paper (cutter
slot), be sure to clean these parts carefully.
Cleaning of post heater cover and pre heater cover
The post heater cover and the pre heater cover are easy to be dirty because of the powder of the media etc.
If it shows dirt, wipe it with a soft cloth soaked in water or waterish mild detergent and wrung.
• Before cleaning the cover, be sure to check that the heater temperature is low enough.
Post heater cover
Maintenance
Pre heater cover
1
1
1
4
4-3
Advertisement
Table of Contents
