Cleaning Exterior Surfaces; Cleaning The Table; When This Machine Is Left Unused For A Long Time - MIMAKI UJF-7151 plus Operation Manual

Cleaning exterior surfaces

Depending on the using environment, the dusts or sand
powder could stick to the exterior of the main unit.
If exterior surfaces of the machine is dirty, to avoid the
entry of the dusts into the moving part of the head, wipe
them off with soft cloth dipped into water or a neutral
detergent diluted with water and squeezed tightly.

Cleaning the table

Remove ink attached to the table with an alcohol-
impregnated cloth. Be careful not to scratch the table face
when removing cured ink.
The vacuum holes on the table can be clogged with ink.
Remove the ink in the vacuum holes when needed. Be
careful not to leave a part of cured ink on the table.
• Be sure to clean the slot on the frame of the table,
the screw holes for holding tools or the like since
dust and dirt are easily accumulated in these
parts.
When this machine is left unused for
a long time
When the machine is not going to be used for a week or
more, use the cleaning function for ink discharge
passage. ( P.4-7 "Washing
Passage")
After this, keep the machine in custody. (
"Turning the Power OFF")
• Use the machine with always turning "ON" the
main power.
• Remove the media being set.
Chapter 4 Maintenance
the Ink Discharge
P.2-3
4-3
1
2
2
4
5
6