Table of Contents
Advertisement
Note for media setting
When setting media, read the following notes carefully.
• Take care not to drop the media on your foot when setting the media.It may cause an injury due to the
media.
• When setting a roll media, work by two or more people. Otherwise, you may hurt your back by the
weight of the roll media.
• When you raise the clamp lever and cut the media with your tools (cutter, scissors, etc.), be sure to
check each item below:
(1) Make TAKEUP setting in "Feeding/TakeUp" of the machine setting "OFF". (
(2) Check that the tension bar is at the lowest position.
• When you set a leaf media and if the media has much warpage, it may get hung up on the post cure
unit and it may scratch up the printing surface. At this time, perform the procedures below:
(1) Use the take-up unit.
(2) Use the machine with the post cure unit open.
However, depending on the printing mode, ink may not be cured. It is recommended to test in
advance.
• In the following cases, the media may not be detected correctly.
When setting a transparent media / when a media is exposed to direct sunshine.
• Do not use a printed media. Otherwise, ink can adhere to the pinch rollers and media may be stained
or may not be detected.
• Straighten the significantly or internally curled media to be fed along the platen.
If the media is left set on the machine for a long time, the media may form an irregular surface for
•
the heat from the print-heater. If printing on such an irregular surface, the head may rub on the
media. If an irregular surface is found on the media, feed the media with the
printing on the irregular surface, and set a new origin. (
• Set the media based on the center of the main body.
• Periodically replace the paper core for taking up the media. If you use the
one whose inner has been peeled due to long-term use as shown in the
right photo, taking up the media cannot be performed normally in some
cases.
2-6
P.3-20)
P.2-27)
key to avoid
Advertisement
Table of Contents
