Table of Contents
Advertisement
3
When charging is complete, remove the IC chip.
• When charging is complete, the ink bottle lamp will flash alternately between orange and green, and a
buzzer will sound.
4
Take out the 1 liter ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
5
Remove the cap of the ink bottle set in the external
ink supply unit.
• First, cover the cap with a waste cloth etc. to prevent your
hands from getting dirty and then remove it.
1-14
• After charging is complete, be sure to remove and dispose of the IC chip. Do not reuse IC
chips.
If the error message "INVALID INK CHARGE" appears on the display
• Charging was not possible for one or more of the following reasons:
(1) Faulty IC chip
(2) Printer ink level at 100%
(3) Attempting to charge ink that has passed its expiration date
For more information about errors, press the
To retry charging, select the "Ink Charge" maintenance function. (
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
Cover with paper towel firmly and shake ink slowly
Repeat this
key in Local. (
P.3-45)
P.3-40)
Cap
Advertisement
Table of Contents
