Table of Contents
Advertisement
When media heaves up at feeding
We call the status of heaving media at feeding "cockling".
When media cockling occurs, check the following items:
Note/ checking items
Checking media set status
Adjusting heater temperature
Media feeding
Do not leave the media in the heater warm-
ing status
Heighten the head
5-12
(1) Check that the media is set straight and reset it.
(1) Use the POST heater only.
(2) Lower all heaters' temperatures.
(1) For roll media, feed the media by about tens of centimeters
to one meter.
(2) For leaf media, press
feed.
(1) Do not start printing with the media cockled because it may
cause media jam.
(1) For the thick media, make the head gap higher before
printing.
Troubleshooting
Measures
and perform feed/ back
Advertisement
Table of Contents
