Disassembly And Replacement - Toshiba DP1600 Service Manual

11.6 Disassembly and Replacement

[A] Charger unit
1. If an ADU (MD-0101) is attached to the copier,
open it.
2. Open side cover. (See Fig.10-3-2)
3. Release 3 hooks and detach the charger unit.
Note: To attach the charger unit, mount 2 springs
to each guide firmly.
[B] Guide roller collar/guide roller gear/
guide roller bush/drum collar
1. If an ADU (MD-0101) is attached to the copier,
open it.
2. Open side cover. (See Fig.10-3-2)
3. Detach the charger unit. (Fig. 11-6-1)
4. Release 2 hooks and detach the guide roller
assembly.
5. Remove 2 guide roller bushes, one guide roller
gear, 2 guide roller collars, and 2 drum collars.
Note: After the guide roller assembly is attached,
the guide roller should rotate smoothly.
[C] Separation charger wire/transfer charger wire
1. If an ADU (MD-0101) is attached to the copier,
open it.
2. Open side cover. (See Fig.10-3-2)
3. Detach the charger unit. (Fig. 11-6-1)
4. Peel off the front and rear protection sheets.
Note: When placing the front and rear protection
sheets on the charger unit, they do not ex-
tend from the charger unit.
December 2000 © TOSHIBA TEC
Spring
Guide roller collar
Drum coller
Guide roller
bush
Front protection sheet
11 - 7 1600/2000/2500 DRUM-RELATED SECTION
Charger unit
Spring
Spring
Fig. 11-6-1
Guide roller bush
Guide roller gear
Guide roller collar
Drum collar
Guide roller
Charger unit
Fig. 11-6-2
Rear protection sheet
Charger unit
Fig. 11-6-3
11-6-1
11-6-2
11-6-3