4.2.4 Bypass-feed copying
Select Bypass Tray with the Paper Supply key on the display.
(1) Place paper in the bypass tray and adjust the document guides F and R to the paper width. The feed
sensor turns ON and the word "Ready for bypass feeding" appears.
(2) Press the START key. The message changes from "Ready for bypass feeding" to "COPYING." The
polygon motor operates. The main motor operates, the process unit fan motor rotates at high speed,
and the discharge lamp lights. The drum, developer, heat roller, and exit roller move.
4.2.5 Interrupt copying
(1) Press the INTERRUPT key. The INTERRUPT key is illuminated and the message "Job interrupted"
appears. The present copy operation is stopped temporarily. The copy mode automatically becomes
the interrupt copy mode.
(2) Interrupt copying takes place.
(3) After the interrupt copying ends, the work "READY" appears. When INTERRUPT key is pressed
again, the illumination of the INTERRUPT key turns off and the copier is restored to its state prior to
the interruption. The message "Ready to resume job" appears.
(4) Press the START key and the operation prior to the interruption is resumed.
1600/2000/2500 COPIER OPERATION
4 - 4
December 2000 © TOSHIBA TEC