Description Of Operations; Part A - Toshiba DP1600 Service Manual

10.2 Description of Operations

10.2.1 Part A

Part A drives the heat roller, feeds (ejects) paper, and transmits drive to the options (OCT, JSP, and
Finisher).
ADU gear
Exit drive gear 6
• Heat roller drive ................... The driving gear train from the main motor drives the HR drive gear 2.
• Exit roller ............................. The driving gear train from the main motor drives the exit drive gear 1.
• Exit drive gear 6 ................... The driving gear train from the main motor drives exit drive gear 6. This
• Exit drive gear 7 ................... The driving gear train from the main motor drives exit drive gear 7. When
1600/2000/2500 DRIVE SYSTEM
Driven by ADU
Fig. 10-2-1
When the ADU is attached, the gear is always driven by the ADU motor
(upper) to slide the gear.
gear transmits the drive from the ADU to the exit roller while the ADU is
attached. When the ADU is attached, the gear cuts off the drive from the
main motor and starts to transmit the ADU drive. Therefore, the exit roller
is always driven by the ADU even in one-side printing when the ADU is
attached.
connected to this gear, the OCT or JSP is driven. (Finisher: DP2000/
2500 series)
10 - 2
Exit drive gear 1 (Exit roller)
OCT or JSP gear
(Finisher : DP2000/2500 series)
Exit drive gear 5
HR drive gear 2 (Heat roller)
Main motor
December 2000 © TOSHIBA TEC
10-2-1 PPS2