Toshiba DP1600 Service Manual page 131

[C] Scanner motor
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, detach it.
2. If a STP (KK-1600) is attached to the copier,
detach it.
3. Detach the manual pocket.
4. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
5. Remove scanner assembly.
(See Fig. 7-8-1 to 7-8-5)
6. Remove original glass. (See Fig. 7-8-6)
7. Detach one connector and detach the motor
harness.
8. Remove one screw and remove the ADF con-
nector plate.
9. Release the clamp and detach the harness.
10. Remove 4 screws and remove scanner motor
assembly while releasing timing belt 157.
11. Remove 4 screws and remove Scanner motor
bracket assembly while releasing scanner tim-
ing belt 142.
Note: Do not mix the screws removed.
December 2000 © TOSHIBA TEC
Motor harness
ADF
connector plate
Screw
Screw
Screw
Scanner motor
bracket 1
7 - 21
Harness
Clamp
Fig. 7-8-8
Timing belt 157
Scanner motor
assembly
Fig. 7-8-9
Scanner motor
bracket assembly
Fig. 7-8-10
1600/2000/2500 SCANNER
044
045
Timing
belt 142
046