Disassembly And Replacement - Toshiba DP1600 Service Manual

9.7 Disassembly and Replacement

[A] Separate holder assembly
1. Remove paper cassette. (See Fig. 2-6-12)
2. Release 4 hooks and remove separate holder
assembly.
[B] Separate roller
1. Remove paper cassette. (See Fig. 2-6-12)
2. Remove separate holder assembly.
(See Fig. 9-7-1)
3. Lift separate roller lever and remove separate
roller assembly.
4. Remove arbor F, draw out shaft, and remove
separate roller, separate spring, arbor R, and
spring cover in this order.
Notes: 1. To detach/attach the separate roller from/
to the separate spring, rotate the sepa-
rate roller in the direction of the arrow.
2. Since the separate spring is coated with
oil, the separate roller should not to be
touched by the separate spring.
[C] Tray-up assembly
1. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
2. Detach the manual pocket.
3. Detach rear cover. (See Fig. 2-6-1)
4. Remove 2 screws and release 2 clamps.
5. Detach the relay connector and remove tray-up
assembly.
1600/2000/2500 PAPER FEEDING SYSTEM
070
spring cover
Separate
Spring
Tray-up
assembly
Screw
037
9 - 10
Separate holder
Hook
assembly
Fig. 9-7-1
Separate roller
Shaft
Spring
Fig. 9-7-2
Relay connector
Clamp
Fig. 9-7-3
December 2000 © TOSHIBA TEC
Arbor F
Spring
071