Toshiba DP1600 Service Manual page 173

7-2. If the main motor is with the flange to the pul-
ley, remove the main drive gear assembly (see
Fig. 10-3-1 to 10-3-4) and attach the main mo-
tor by following the procedure below.
Attaching the main motor
1. After attaching the main motor to the main drive
gear assembly, remove the main drive gear
cover assembly by removing the four screws.
2. Remove the gear to remove the spring.
3. Loosen 2 screws and attach timing belt 176.
4. Attach the spring and tighten 2 screws.
5. Attach the gear and then the main drive gear
cover assembly.
Note: When the main drive gear assembly is at-
tached, adjust it by referring to the Service
Handbook. (See chapter 1.9)
(DP2000/2500 series)
1. If STP(KK-1600) is attached to the copier, dis-
connect the power cable.
2. Detach the manual pocket.
3. Detach the toner cartridge and the process unit.
4. Detach rear cover. (See Fig. 2-6-1)
5. Remove PC I/F PWA. (See Fig. 2-6-27)
6. Remove 3 screws to remove the drum drive
shaft holder.
1600/2000/2500 DRIVE SYSTEM
Screw
Fig. 10-3-6
Spring
Gear
Fig. 10-3-7
Drum drive shaft
holder
Screw
Fig. 10-3-8
10 - 8
01/09
Main drive gear
cover assembly
Screw
032-3
Timing belt 176
Screw
032-4
031-3
December 2000 © TOSHIBA TEC