Toshiba DP1600 Service Manual page 133

(DP2000/2500 series)
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, detach it.
2. Detach top cover. (See Fig. 2-6-2)
3. Detach 2 connector from INV PWA (CN1/CN2).
4. Remove 2 screws and remove INV PWA as-
sembly.
5. Remove 2 screws, release 2 locking supports,
and remove INV PWA.
[E] Scanner PWA
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
2. Remove original glass. (See Fig. 7-8-6)
3. Remove 4 screws and remove blind plate.
Note: If the damp heater is installed, release one
hook and detach one connector.
(TWD/SAD/ASD/AUD/CND models)
December 2000 © TOSHIBA TEC
Connector
Screw
INV PWA assembly
Locking
support
INV PWA plate
Screw
Blind plate
Connector
Screw
7 - 23
Connector
Screw
Fig. 7-8-14
INV PWA
Locking
support
Fig. 7-8-15
Screw
Fig. 7-8-16
Screw
Blind plate
Fig. 7-8-17
1600/2000/2500 SCANNER
049-3
Screw
049-4
050-1
050-2