Toshiba DP1600 Service Manual page 36

[F] Control panel front cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover.
(See Fig. 2-6-3 and 2-6-4)
4. Remove one screw, release one tab, and detach
control panel front cover.
[G] Control panel bottom cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover.
(See Fig. 2-6-3 and 2-6-4)
4. Detach control panel front cover.
(See Fig. 2-6-7)
5. Remove 2 screws, release one tab, and detach
control panel bottom cover.
[H] Control panel
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover.
(See Fig. 2-6-3 and 2-6-4)
4. Detach control panel front cover.
(See Fig. 2-6-7)
5. Detach control panel bottom cover.
(See Fig. 2-6-8)
6. Remove one screw and detach the ground wire.
7. Detach control panel harness.
8. Remove 2 screws at the lower part of control
panel, release 2 hooks, and remove control panel.
Note: When attaching the control panel, secure it
with the clamp to prevent the core from drop-
ping.
December 2000 © TOSHIBA TEC
Screw
Fig. 2-6-7
Screw
Clamp
Fig. 2-6-9
2 - 23 1600/2000/2500 OUTLINE OF THE MACHINE
01/05
Control panel front cover
Screw
Control panel
bottom cover
Fig. 2-6-8
Control panel
Screw
Ground wire
Screw
Screw
Core
Control panel harness
006-1
006-2
007