No.
Component
Connector
(CONNECTOR, 1 - 9)
5, 34
28
Connector 1
(CONNECTOR, 1)
5, 6, 34, 35, 44, 45
29
Connector 2
(CONNECTOR, 2)
5, 34, 36, 45
30
Procedure
34.Cut the cable tie that fixes the connector
(CONNECTOR, 1 - 9), then pull out the fastening
terminals of the connectors.
Note:
When cutting the cable tie, be careful not to cut the
lead wire unintentionally.
• Note on connecting
Connect the fastening terminal firmly, and make
sure the fastening terminal holds the tab terminal
securely.
(Do not insert the tab terminal between the
fastening terminal and sleeve.)
• Note on connecting
Insert the connector firmly.
(After inserting the connector, pull it slightly to
make sure it is firmly inserted.)
35.Pull out the fastening terminals of the power
supply terminal block (TERMINAL BLOCK, 2P),
relay (RELAY, LY-1F), and capacitor
(CAPACITOR).
Remove the connector connecting connector 1
and 2 (CONNECTOR, 1 and 2).
36.Pull out the fastening terminal of the relay
(RELAY, LY-1F).
Remove the connector connecting connector 1
and 2 (CONNECTOR, 1 and 2).
CONNECTOR, 1
(Lower)
CONNECTOR, 6
(Lower)
CONNECTOR, 7
CONNECTOR, 8
60
Note
CONNECTOR, 1
CONNECTOR, 5
CONNECTOR, 8
CONNECTOR, 7 (Upper)
CONNECTOR, 5
CONNECTOR, 4
CONNECTOR, 9