Download  Print this page

Installation; Fixing The Unit - Toshiba VN-M150HE Service Manual

Air to air heat exchanger concealed microcomputer control type
Hide thumbs

Advertisement

Table of Contents
7

Installation

Attaching the adapter
• Attach the adapter to the unit using the accessory
screws (4 or 6).
Adapter
Attaching the washer and the
nut
1) Preparation of the hanging bolt, nut, and
washer is required.
2) Attach the washer and the nut to the hanging
bolt (see the table on the below) according to
the diagram on the below.
Hanging bolt
(M10 or M12)
Nut (M10 or M12)
Hanging bracket

Fixing the unit

Hanging bolt
(M10 or M12)
1) Hang the hanging bracket on the hanging bolt,
then adjust the nut so that the unit is level.
2) Use a double nut and fasten it firmly so that the
nut does not become loose.
• If the unit is not installed properly, it will vibrate
and may pose a hazard.
• If the unit is not level, the damper unit will not
work properly.
• Install the unit firmly enough to support its own
weight.
Screws (accessory:
4 or 6 screws)
Washer (M10 or M12)
Washer (M10 or M12)
Use the washer just under
the hanging bracket to
prevent the bolt from
falling off.
Nut (M10 or M12)
Hanging bolt
Nut
Washer
Hanging
bracket
Washer
Nut
Model name
VN-M150HE
VN-M250HE
VN-M350HE
VN-M500HE
VN-M650HE
VN-M800HE
VN-M1000HE
CAUTION
• Use a commercially available vibration-proof fixture
when the unit is installed in a place where preventing
vibration is necessary.
• Leave a space of 450mm x 450mm or more for
checking the filter, heat exchanging element, power
source, or motor. Refer to "Cautions for Installation"
for the location of the space required.
Hanging bolt
Vibration-proof fixture
Unit
Cautions installing unit body
upside down
• The hanging bracket does not need to be replaced.
• The printed image is reversed.
101
Weight (kg)
Hanging bolt
36
36
38
53
M10, M12
53
70
70
Vibration-proof fixture

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Toshiba VN-M150HE