Select a timer type from the following three: (Max. 168 hours)
Setting the timer
The operation lamp lights up.
Each time the button is pushed, the timer mode
and indication change in the following order:
and the time indication blink.
buttons to set the period of
time until the timer actions.
• The time setting increases in 0.5-hour (30
minute) increments each time
The setting increases in 1-hour increments if it is
over 1 day (24 hours). The maximum is 7 days
On the remote controller, settings between 0.5
hours and 23.5 hours (*1) are displayed as is.
For settings over 24 hours (*2), the days and
hours are displayed.
• The time setting decreases in 0.5-hour (30
minute) decrements (0.5 hours to 23.5 hours) or
1-hour decrements (24 hours to 168 hours)
Example of indication on the remote controller
• 23.5 hours (*
: Stops running after a specified period.
: Stops running after a specified period every time the unit is used.
: Starts running after a specified period.
button to start operation.
• 34 hours (*
indicates 1 day
indicates 10 hours.
(Total: 34 hours)
disappears, the time indication is
(When using the ON timer, all indications other
than the time indication and
Cancelling the timer
The timer indicator disappears.
• When using the Repeat-OFF timer, pressing the
button after the unit has been stopped by
the timer starts it running again, and the unit will stop
again after the specified period.
• When 24-hour ventilation or the nighttime heat purge
operation is activated, the unit is running the
activated operation while the unit stops following the