Toshiba VN-M150HE Service Manual page 68

• If there is a danger of the Air to Air Heat Exchanger's falling, do not approach the Air to Air Heat Exchanger but set
the circuit breaker to the OFF position, and contact a qualified installer or a qualified service person to refit the unit.
Do not set the circuit breaker to the ON position until the unit has been refitted.
• Do not modify the products. Do not also disassemble or modify the parts. It may cause a fire, electric shock or injury.
Relocation
• When the Air to Air Heat Exchanger is to be relocated, do not relocate it yourself but contact a qualified installer or a
qualified service person. Failure to relocate the Air to Air Heat Exchanger properly may result in electric shocks and/
or a fire.
(*1) Refer to the "Definition of Qualified Installer or Qualified Service Person."
CAUTION
To Disconnect the Appliance from the Mains Supply
• Means for disconnection having a contact separation in all poles at least 3 mm must be incorporated in the fixed
wiring in accordance with the wiring rules.
The Installation Fuse (All Types Can Be Used) Must Be Used for the Power Supply Line of This Air to Air
Heat Exchanger.
Cautions about Installation (confirm the following cautions.)
• Connect the Air to Air Heat Exchanger to an exclusive power supply of the rated voltage, otherwise the unit may
break down or cause a fire.
Cautions about Operation
• Do not use this Air to Air Heat Exchanger for special purpose such as preserving food, precision instruments, art
objects, breeding animals, car, vessel, etc.
• Do not touch any switches with wet finger, otherwise you may get an electric shock.
• If the Air to Air Heat Exchanger will not be used for a considerably long time, turn off the main switch or the circuit
breaker, for safety.
• Prevent any liquid from falling into the remote controller. Do not spill juice, water or any kind of liquid.
• Do not pour or spray water or detergent on the electric parts.
Doing so may cause electric leakage and result in a fire, electric shocks and/or injury.
• Do not install the unit and inside air intake in a place such as a machine factory, chemical plant, or research
institute, where acids, alkaline, organic solvents, or coating materials are handled and toxic gases and/or
corrosive gases may be produced.
Otherwise, gas poisoning may occur and/or the inside of the unit may be eroded or deteriorated. The
deterioration and erosion may result in a fire.
• Do not use "Bypass mode" when heating the room in winter.
Water condensed on the unit may drip onto the ceiling board and may soil the ceiling.
• Do not use the unit in a place where it is hot (40°C or higher) or where much oily smoke is produced, and do not
directly expose the unit to flame.
Doing so may result in a fire.
• Do not expose animals or plants to the wind from the unit.
Doing so may harm the animal or plant.
• Do not use a flammable spray near the unit or inside air intake.
Doing so may result in a fire.
Disposal
Dispose of Air to Air Heat Exchanger in accordance with the 2002/96/EC Directive WEEE (Waste Electrical and
Electronic Equipment).
67