No.
Component
Electrical control base
(LID, ELECTRIC
PARTS)
Tapping (SCREW,
TAPPING)
5, 24, 25, 26
20
Procedure
24.Disconnect all the connectors from the PC board
(PC BOARD).
Thread all the connectors through the cord
bushes.
25.Remove the two tapping screws (SCREW,
TAPPING), then remove the electrical control
base (LID, ELECTRIC PARTS).
Electrical control base
(LID, ELECTRIC PARTS)
57
Note
Electrical control
base
(LID, ELECTRIC
PARTS)
: Connectors
Cord bush
Tapping screws
(SCREW,
TAPPING)
Electrical control box
(BOX, ELECTRIC PARTS)