No.
Component
Electrical control cover
(COVER, PC BOARD)
5
5
Connector of MOTOR
5, 6
6
Cover (COVER, WIRE)
1, 2, 7
7
Procedure
5. Remove the four screws (M4×6) that fix the
electrical control cover (COVER, PC BOARD),
then remove the cover.
6. Open the electrical control base (LID, ELECTRIC
PARTS), and disconnect the connector
(CONNECTOR, 1) connected to the connector of
motor.
Note:
The connector of the supply motor (MOTOR,
SUPPLY) is white.
The connector of the exhaust motor (MOTOR,
EXHAUST) is black.
7. Remove the four screws (M4×6) that fix the cover
(COVER, WIRE), then remove the cover.
52
Note
Screws (M4×6)
Screws (M4×6)
Electrical control base
(LID, ELECTRIC PARTS)
Push this part
with your nail to
disconnect the
connector.
Screws (M4×10)
Cover (COVER, WIRE)
Top and bottom
Electrical
control
cover
(COVER,
PC
BOARD)