Remote controller for the Air to Air Heat Exchanger NRC-01HE
◆ Operation section
• One of these remote controllers can be used to control both indoor air
conditioner units and Air to Air Heat Exchangers (up to 8 units in total).
• After setting the operation conditions, you can use the units by just pressing
the ON/OFF button.
• Functions concerning controlling the Air to Air Heat Exchanger are
explained here. For controlling an air conditioner, refer to the owner's
manuals supplied with the air conditioner.
button (Fan speed select button) (*1)
Selects the desired Fan speed.
button (Timer set button)
Used for timer setting.
button (Test button)
Used for service.
Do not use this button in everyday operations.
button (Ventilation button)
This button is used when the Air to Air Heat
Exchanger is in a system linked with air
conditioners. Push the
the Air to Air Heat Exchanger. Turning on/off the
air conditioner also turn on/off the Air to Air Heat
* No Air to Air Heat Exchanger is connected or
separate operation of the Air to Air Heat
Exchanger is not set, if "
remote controller display after pushing the
button (Filter reset button)
FILTER" indication after cleaning.
button to turn on/off
" appears on the
button (Power save operation) (*1)
Use to initiate power saving mode.
button (Swing/Louver direction
Use to select automatic swing or fixed louver
* Not available for concealed duct, slim duct, floor
concealed and floor standing cabinet fresh air
Lights up during operation.
Blinks when an error occurs or the protective
Turns on the unit when pressed, and turns it off
when pressed again.
button (Operation mode select button)
Selects desired operation mode.