Loading Uefi Bios Setup Defaults (J-Gp) - EKF SC2-PRESTO CompactPCI User Manual

User Guide • SC2-PRESTO • CompactPCI
The following table shows the factory settings of DS-P with different side boards mounted to the
SC2-PRESTO:

Loading UEFI BIOS Setup Defaults (J-GP)

The jumper J-GP may be used to reset the UEFI BIOS configuration settings to a default state. The UEFI
BIOS on SC2-PRESTO stores most of its settings in an area within the BIOS flash, e.g. the actual boot
devices. Using the jumper J-GP is only necessary, if it is not possible to enter the setup of the BIOS. To
reset the settings mount a jumper on J-GP and perform a system reset. As long as the jumper is
stuffed the BIOS will use the default configuration values after any system reset. To get normal
operation again, the jumper has to be removed.
© EKF
Side Board
1
None OFF
CCI-RAP OFF
CCK-MARIMBA ON
CCL-CAPELLA ON
PCS-BALLET OFF
J-GP
1)
Jumper Removed Normal operation
Jumper Installed BIOS configuration reset performed
1)
This setting is the factory default
®
Serial CPU Board • Intel® Core
DS-P PCIe Link Width
2 P-PCIE
OFF 4 Links x 1 Lane @ 5GT/s
OFF 4 Links x 1 Lane @ 5GT/s
OFF 1 Link x 4 Lanes @ 5GT/s
OFF 1 Link x 4 Lanes @ 5GT/s
OFF 4 Links x 1 Lane @ 5GT/s
1
J-GP
Function
-58-
TM
4xxx Processor
ekf.com