Related Manuals for EKF CompactPCI CC5-RAVE
Summary of Contents for EKF CompactPCI CC5-RAVE
- Page 1 BIOS Quick Reference ® CompactPCI CC5-RAVE • FC-PGA 370 CPU Document No. 2508 • Preliminary Edition 2 09-2001...
-
Page 2: Table Of Contents
Serial Port Configuration ..........16 - 2 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... - Page 3 Addendum B: Embedded BIOS Beep & Blink Codes ......25 - 3 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de...
-
Page 4: About This Manual
This manual has been edited as carefully as possible. We apologize for any potential mistake. Information provided herein is designated exclusively to the proficient user (system integrator, engineer). EKF can accept no responsibility for any damage caused by the use of this manual. - 4 - EKF Elektronik GmbH * Philipp-Reis-Str. -
Page 5: Overview
The CC5-RAVE board is licensed with a single copy of Embedded BIOS software from General Software, Inc. General Software may be reached on the web at http://www.gensw.com. The BIOS has been adapted to the particular CC5-RAVE hardware by EKF. BIOS updates will be available by download at http://www.ekf.de/c/ccpu/cc5/cc5.html. E-Mail support can be obtained directly by support@ekf.de. - Page 6 If you find that the graphical POST comes back after several boots, it is because this option is enabled for this platform. EKF can arrange to control whether Setup can be used to dictate the policy, and whether it is permanent or temporary.
-
Page 7: Setup Screen System
Modified BIOS adjustments can be either permanently saved (‘Write to CMOS and Exit’), or abandoned (‘Exit without changing CMOS’). - 7 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 8: Basic Cmos Configuration Screen
CMOS options are automatically loaded from the BIOS Flash (factory default parameters) and have to be reconfigured (if necessary) by the user. - 8 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 9: Numlock
“G” at the debugger prompt and press ENTER. None No action; POST proceeds to the next activity in the sequence. - 9 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 10: Configuring Floppy Drive Types
CD-ROM drives you should select option "AUTOCONFIG, PHYSICAL", for greater drives select "AUTOCONFIG, LBA". Option "AUTOCONFIG, PHOENIX" is not in common use any more. Select - 10 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 11: Miscellaneous Settings
This option defines whether the memory area above 1MB will be tested during the POST. - 11 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 12: Int 3 Instruction
Determines whether a graphic screen is shown during the POST and boot process. The graphic can be customized to your individual needs (e.g. company logo) by EKF. - 12 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 13: Custom Configuration Setup Screen
Ethernet controller and the PCI bridge. 0-2 would include all those devices outside the CC5- - 13 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 14: Buses Behind Bridges
Ignored (factory default): PCI buses behind bridges with Class Code 0xFF will be ignored, i.e. these buses will NOT be scanned for PCI devices For systems containing EKF I/O boards which are equipped with the i960 CPU/bridge (e.g. CU1, CU2, CG1, CM1, CX1) this option must be set to ‘ignored’. -
Page 15: Level 2 Cache
Debugger I/O redirection cannot be aborted on pressing any key on the PS/2 keyboard - 15 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 16: Parallel Port Configuration
2F8h, 338h, 3E8h, 3F8h). You can select either of IRQ 3/4/5/7. If in doubt, select 3F8h IRQ 4 for UART1 (COM1) and 2F8h IRQ 3 for UART2 (COM2). - 16 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 17: Ide Configuration Setup Screen
80-pos. IDE cable being present - this option is required for an HDD directly mounted on the CC6-ACID). - 17 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 18: Master/Slave Timing Mode
IDE port but the UDMA parameter. No IDE slave device is attached. - 18 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 19: Password Configuration
You will have to reconfigure all BIOS settings now. - 19 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 20: Standard Diagnostics Routines Setup Screen
BIOS retries operations when failures occur during normal operation of the system. - 20 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 21: System Bios Debugger
“G” command (short for “go”) and press ENTER. If you were at a DOS prompt when you entered - 21 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... -
Page 22: Console Redirection
The software on the target can be any terminal emulation program that supports ANSI terminal mode, using 9600 baud, no parity, and one stop bit (Note: This can be modified by EKF during BIOS adaptation.) The program must be set to not use flow control, or the console may seem to stall or not accept input. -
Page 23: Addendum A: Embedded Bios Post Codes
POST_STATUS_PWRONDISPLAY 37h Display power-on message. POST_STATUS_SAVECURSOR 38h Save cursor position. POST_STATUS_BIOSIDENT 39h Display BIOS identification string. - 23 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... - Page 24 POST_STATUS_POSTNPX 9dh Numeric coprocessor initialized. POST_STATUS_CHECKLOCKS 9eh Check KB settings. POST_STATUS_ISSUEKBDID 9fh Issue keyboard ID command. - 24 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de...
-
Page 25: Addendum B: Embedded Bios Beep & Blink Codes
Data line test failed POST_BEEP_INTERRUPT Interrupt controller test failed POST_BEEP_PASSWORD Incorrect password used to access SETUP - 25 - EKF Elektronik GmbH * Philipp-Reis-Str. 4 * D-59065 HAMM (Germany) Tel. +49 (0)2381/6890-0 * Fax. +49 (0)2381/6890-90 * E-Mail info@ekf.de * Internet http://www.ekf.de... - Page 26 BIOS Quick Reference • CC5-RAVE EKF Elektronik GmbH Internet http://www.ekf.de Philipp-Reis-Str. 4 Fax. +49 (0)2381/6890-90 D-59065 HAMM Tel. +49 (0)2381/6890-0 (Germany) E-Mail sales@ekf.de...
Need help?
Do you have a question about the CompactPCI CC5-RAVE and is the answer not in the manual?
Questions and answers