Hummer H1 Service Manual page 704

_____________________________________________________________________
®
Door Stop Replacement
Removal
1. Remove rear door window.
2. Remove four screws and interior door handle from door
(Figure 10-149).
3. Remove twelve screws and close-out panel from door.
4. Remove bolt, door stop ball, and retainer from door
(Figure 10-151).
5. Remove bolt, washer, door stop socket, and retainer from
right rear wheelhouse.
RETAINING
BLOCK
LATCH
GUIDE
RETAINER
Figure 10-151: Door Stop and Latch Guide
Replacement
Installation
1. Secure door stop socket to right rear wheelhouse with
washer, bolt, and retainer (Figure 10-151).
2. Secure door stop ball to door with bolt and retainer.
3. Secure close-out panel to door with twelve screws
(Figure 10-149).
4. Secure interior door handle to close-out panel with four
screws.
5. Install rear door window.
Latch Guide Replacement
Removal
Remove latch guide, two washers, and retaining block from
door frame (Figure 10-151).
Installation
Secure latch guide to door frame with two washers and retain-
ing block (Figure 10-151).
Adjustment
Close door and check alignment, then adjust latch guide as
necessary.
05745159
Door Frame and Seal Replacement
Removal
1. Remove dome lamp fuse.
2. Remove seven screws securing inner portion of door hinge
to door frame.
3. When hinge is loose, carefully pull away to access
connectors for door lock contacts in the hinge.
4. Disconnect the door lock harness connectors, label them
for reassembly.
5. Remove vertical doors from door frame.
6. Remove upper and lower latch guides.
7. Remove inner passenger side closeout panel on inside of
door frame.
8. Disconnect dome lamp switch harness from door jamb
DOOR STOP switch.
SOCKET
9. Remove fourteen screws from door frame (Figure 10-152).
10. Remove door frame completely
11. Remove seal from door frame.
DOOR
STOP
BALL
Figure 10-152: Door Frame and Seal Replacement
Installation
1. Position seal on door frame (Figure 10-152).
2. Secure door frame to vehicle with fourteen screws.
3. Install a new door jamb switch and connect to dome lamp
harness.
4. Install upper and lower latch guides.
5. Install vertical doors on door frame.
6. Connect door lock harness connections to the back of the
door hinge contacts.
7. Install interior closeout panel.
8. Close door to adjust new door jamb switch.
9. Install dome lamp fuse.
10. Verify operation of door lamps and cargo switch.
Body 10-77
DOOR
FRAME
SEAL