Hummer H1 Service Manual page 438

______________
®
Installation
NOTE: Ensure that any new fittings have pipe sealant pre-ap-
plied to threads. If none is present, apply a pipe sealant to fit-
ting threads.
1. Secure auxiliary air valve to existing tee (Figure 6-81).
COMPRESSOR
9-S06-017
05745159
Wheels and Tires/Central Tire Inflation System (CTIS)
Figure 6-81: CTIS Auxiliary Air Hose
2. Connect tires to CTIS by pushing in quick-disconnect
valve body until valve tee section locks (clicks) into place.
Perform this procedure on remaining three wheels
(Figure 6-80).
3. Start engine and check CTIS for air leaks around installed
fittings.
4. Lower and secure hood.
AUXILIARY
AIR VALVE
EXISTING TEE
AIR HOSE
6-55