Hummer H1 Service Manual page 653

______________________________________________________________________
10-26 Body
Installation
1. Secure trim mounting brackets to B-bar with four washers
and screws (Figure 10-36).
2. Install B-bar.
3. Secure mounting blocks to B-pillar with washers, bolts
and locknuts. Tighten locknuts to 24 lb-ft (33 N•m).
4. Secure strikers to B-pillar with washers and locknuts.
5. Install B-pillar seals and rabbet seals on B-pillar.
6. Secure mounting brackets to mounting blocks with
lockwashers and screws.
7. Secure headliner support to B-bar with washers and
screws.
8. Install domelight.
9. Install trim on B-bar.
10. Install seat belt assemblies.
Passenger's Compartment Trim
Replacement
Removal
1. Remove rear seats.
2. Remove overhead speakers (Section 12).
3. Remove seat belt assemblies.
4. Remove screw/washer assemblies and B-bar center trim
from roof (Figure 10-37).
COVER
GRAB
HANDLE
UPPER
B-BAR
TRIM
Figure 10-37: Driver Side Interior Trim Component
Identification
5.
6.
7.
NOTE: Perform steps 8 through 10 for station wagon models
only.
8.
9.
10. Remove screw/washer assemblies and lower C-pillar trim
C-PILLAR
ROOF
C-PILLAR
11. Remove screw/washer assemblies and trim panel from
CENTER
B-BAR
TRIM
B-PILLAR
TRIM
Remove covers, screws, and grab handle from trim.
Remove screw/washer assemblies and upper B- bar trim
from roof.
Remove screws, washers, and lower B-pillar trim from B-
pillar.
Remove screw/washer assemblies and C-pillar center trim
from roof (Figure 10-38).
Remove screw/washer assemblies and upper C-pillar trim
from roof.
from lower C-pillar.
C-PILLAR
CENTER TRIM
UPPER
C-PILLAR
TRIM
LOWER
TRIM
Figure 10-38: Station Wagon Interior Trim
Component Identification
rear compartment wall (Figure 10-39)
®
ROOF
HEADLINER
REAR
COMPARTMENT
WALL