Hummer H1 Service Manual page 682

_____________________________________________________________________
®
WINDSHIELD
ASSEMBLY
Figure 10-105: Windshield Assembly Seal
Replacement
Installation
1. Position two seals on windshield assembly
(Figure 10-103).
2. Position windshield assembly over A-pillar.
3. Secure windshield assembly to two brackets with six bolts
and washers.
4. Connect two jumper harness leads to body harness leads
and insert grommet into windshield center pillar
(Figure 10-104).
5. Secure windshield assembly to A-pillar with two bolts and
locknuts (Figure 10-103).
6. Install windshield wiper arm pivots.
7. Install windshield wiper linkage.
8. Install windshield wiper arm and blade.
9. Install soft top.
05745159
FORMER
SEAL
CORNER CAP
HEATED WINDSHIELD
The optional heated windshield is capable of defrosting the
windshield glass in less than 10 minutes at 0° F. The system is
comprised of a rocker switch with an integrated time delay
module (Figure 10-106), two relays, and two fuses , and in-
glass heating elements.
CONNECTOR
CLIPS
(NOT SHOWN)
POWER WINDOW
MASTER SWITCH
Figure 10-106: Rocker Switch/Time Delay Module
Location
HEATING
DRIVER
ELEMENT
SIDE
JUNCTIONS
WINDSHIELD
GLASS
Figure 10-107: Heating Element Junction
Location
The rocker switch/time delay module is mounted on the power
window master switch on the driver side of the front console
(Figure 10-106).
Body 10-55
ROCKER
TIME DELAY
SWITCH
MODULE
FRONT
CONSOLE
INDICATOR
LIGHT
ASSEMBLY
PASSENGER SIDE
WINDSHIELD GLASS
FRONT
CONSOLE