Hummer H1 Service Manual page 1018

____________________________________________________________
®
CARGO BED-MOUNTED SPARE TIRE CARRIER
REPLACEMENT
WARNING: Always support the tire and wheel assem-
bly when removing the lug nuts. The tire and wheel as-
sembly weighs approximately 160 lbs (72 kgs) and may
cause personal injury if it is not supported properly.
NOTE: Cargo bed-mounted spare tire carrier may be located
either directly behind the cab or at the left wheelhouse on two
door models. On four door models, spare tire carrier will be lo-
cated at the left wheelhouse.
Removal
NOTE: Perform steps 1 and 2 on vehicles with frame assem-
bly stowed in down position.
1. Disconnect lock pins and raise frame assembly to upright
position (Figure 13-29).
FRAME ASSEMBLY
LOCK
PIN
Figure 13-29: Cargo Bed-Mounted Spare Tire
Carrier Appearance
2. Secure frame assembly in upright position with lock pins.
3. Remove lug nuts securing tire to frame assembly and
remove wheel/tire assembly.
4. Remove self-tapping screws, lockwashers, and lanyard/lock
pin assemblies from mounting brackets (Figure 13-30).
5. Remove locknuts, bolts and frame assembly from
mounting brackets.
6. Remove screws securing mounting brackets to cargo floor
(Figure 13-31).
7. Remove bolts, lockwashers, washers, and mounting
brackets from cargo floor.
05745159
WHEEL/TIRE ASSEMBLY
FRAME
ASSEMBLY
MOUNTING
LANYARD AND
LOCK PIN ASSEMBLY
Figure 13-30: Frame Assembly Mounting
MOUNTING
BRACKET
Figure 13-31: Mounting Bracket Positioning
Installation
1. Install mounting brackets on cargo floor with washers,
lockwashers, and bolts (Figure 13-31).
2. Secure mounting brackets to cargo floor with screws.
Tighten screws to 44 lb-ft (60 N•m).
3. Install frame assembly on mounting brackets with bolts
and locknuts (Figure 13-30).
4. Install lanyard/lock pin assemblies on mounting brackets
and frame assembly with lockwashers and self-tapping
screws.
5. With carrier in the upright position, install tire on frame
assembly with three lug nuts (Figure 13-29).
NOTE: Perform steps 6 and 7 to stow frame assembly in down
position.
6. Disconnect lock pins and lower frame assembly to down
position.
7. Connect lock pins.
Accessories 13-13
BRACKET
CARGO FLOOR