Inner Kick Panels Replacement - Hummer H1 Service Manual

______________________________________________________________________
10-32 Body

Inner Kick Panels Replacement

Removal
1. Remove seats.
NOTE: Remove one bolt, washer, and seat buckle for two-pas-
senger models.
2. Remove bolts, washers, and seat buckles from front and
rear of tunnel (Figure 10-50).
SEAT BUCKLE
Figure 10-50: Seat Belt Buckle Electrical
Connector Location
NOTE: Ensure seat belt buckle electrical connector or wiring
harness is pulled out and away from kick panel for ease of in-
stallation.
3. Disconnect seat belt buckle electrical connector from
wiring harness connector on driver side.
NOTE: Perform steps 4 and 5 for four-passenger models only.
4. Remove panel fasteners, screw/washer assemblies, and
rear wall trim from rear compartment wall (Figure 10-51).
5. Remove panel fasteners and rear inner kick panel from
tunnel (Figure 10-52).
B-BEAM
TRIM
WIRING
HARNESS
CONNECTOR
SEAT BELT BUCKLE
ELECTRICAL
CONNECTOR
REAR
COMPARTMENT
WALL
REAR
COMPARTMENT
WALL TRIM
Figure 10-51: Rear Compartment Trim Removal
RIGHT FRONT
INNER KICK PANEL
TUNNEL
SHIFT
CONTROL
TRIM PANEL
LEFT FRONT
INNER KICK
PANEL
REAR INNER
KICK PANELS
Figure 10-52: Inner Kick Panel Mounting
6. Remove front and center consoles.
7. Remove screw/washer assemblies, panel fastener, and
shift control panel from tunnel (Figure 10-52).
8. Remove panel fasteners and left front inner kick panel
from tunnel.
9. Remove panel fasteners and right front inner kick panel.
NOTE: Perform step 10 for two-passenger models only.
10. Remove panel fastener and inner kick panel from rear of
tunnel.
PANEL
PANEL
FASTENER
TWO PASSENGER
VEHICLE ONLY
KICK
PANEL
®