Hummer H1 Service Manual page 1007

13-2 Accessories
CLAMP
FRAME BRACKET
POWER CABLES
Figure 13-2: Frame Bracket
4. Remove four nuts, washers, bolts, and winch from front
bumper (Figure 13-3).
CLAMP
WINCH
FRONT BUMPER
Figure 13-3: Winch and Winch Cables
5. Remove two bolts and clamps securing winch cables to
winch.
6. Remove bolt and control box cover from winch.
7. Remove capscrew, washer, and negative winch cable from
winch.
8. Remove bolt and positive winch cable from winch.
_______________________________________________________________
POSITIVE
CONTROL
WINCH
CABLE BOX
COVER
NEGATIVE
WINCH
CABLE
Installation
1. Install positive winch cable on winch with bolt (Figure 13-3).
2. Install negative winch cable on winch with washer and
capscrew.
3. Coat motor end of winch with coating compound.
4. Install control box cover on winch with bolt.
5. Secure two winch cables to winch with two clamps and bolts.
6. Install winch on front bumper with four washers, bolts,
and nuts. Tighten bolts to 60 lb-ft (81 N•m).
7. Route winch power cables through the splash shield.
8. Install winch cables on frame bracket with clamp,
capscrew, lockwasher, and nut (Figure 13-2).
9. Connect battery ground cables (Section 12).
Winch Cable Replacement
WARNING: To avoid injury, wear gloves when han-
dling winch cable.
Removal
1. Unwind winch cable.
2. Remove set screw and winch cable/hook assembly from
drum assembly (Figure 13-4).
SET SCREW
CABLE ANCHOR
Figure 13-4: Winch Cable
Installation
3. Install winch cable/hook assembly on drum assembly with
set screw.
CAUTION: Install winch cable on drum under a load of at
least 500 lb (227 kg), or outer wraps will draw into
inner wraps and damage cable.
NOTE: Spool winch cable according to rotation label on
winch or brake will not function.
4. Rewind and lubricate winch cable.
®
CABLE/HOOK
ASSEMBLY