Hummer H1 Service Manual page 678

_____________________________________________________________________
®
Right Hood Close-Out Seal and Retainer
Replacement
Removal
1. Remove two screws and upper seal retainer from close-out
seal and hood (Figure 10-97).
2. Remove two screws, lower seal retainer, and close-out seal
from hood.
LOWER SEAL
RETAINER
HOOD
CLOSE-OUT
SEAL
WELLNUT
Figure 10-97: Right Hood Close-Out Seal Location
3. Inspect four wellnuts for damage. Replace if defective or
damaged.
Installation
1. Secure close-out seal and lower seal retainer to hood with
two screws (Figure 10-97).
2. Secure upper seal retainer to close-out seal and hood with
two screws.
05745159
UPPER SEAL RETAINER
Airlift Bracket Seal Replacement
NOTE: Turbo Diesel models have thick foam pads around the
inside of the hood grille. These pads help to direct air flow
through the radiator and provide better engine cooling. The up-
per pad is held down by the air lift bracket seal and seal protec-
tor. (Figure 10-98).
Removal
Lift protector and seal from airlift bracket (Figure 10-98).
Installation
Slide seal and protector onto airlift bracket (Figure 10-98).
UPPER
PAD
RETAINING
PLATES
Figure 10-98: Foam Pad Mounting
Body 10-51
SEAL
PROTECTOR
AIRLIFT
BRACKET
SEAL
SIDE
PAD
SPLASH
SHIELD
SEAL