Hummer H1 Service Manual page 649

______________________________________________________________________
10-22 Body
SEAT BELT ASSEMBLY REPLACEMENT
NOTE: Replacement of the seat belt assembly is basically the
same for all seat locations on all vehicle models. This proce-
dure covers the left front seat belt on four-door hard top vehi-
cles.
Removal
1. Remove seat.
2. Remove screw/washer assembly, seat buckle, and washer
from body (Figure 10-30).
3. Remove inner kick panel enough to gain access to seat
buckle electrical connector.
4. Disconnect seat buckle electrical connector from roof
harness connector and pull seat buckle electrical connector
through grommet in inner kick panel.
SEAT
BUCKLE
Figure 10-30: Seat Belt Electrical Connector
5. Remove screw/washer assembly, D-ring, webbing guide
cover, and washer from B-pillar (Figure 10-31).
ROOF
HARNESS
CONNECTOR
SEAT BELT
ELECTRICAL
CONNECTOR
INNER
KICK PANEL
Location
WEBBING
GUIDE
COVER
D-RING
LOWER
B-PILLAR TRIM
RETRACTOR
COURTESY
LIGHT
Figure 10-31: Seat Belt Assembly Breakdown
6. Remove screw/washer assembly, anchor bracket, and
washer from bracket.
NOTE: Steps 8 and 9 are applicable to all vehicles except two-
door vehicles with the enlarged cab.
7. Remove courtesy light lamp assembly, rivets, mounting
bracket, and washers from lower B-pillar trim (Figure 10-31).
8. Disconnect body harness connector from courtesy light
lamp assembly.
9. Remove screw/washer assemblies securing lower B-pillar
trim to B-pillar.
10. Remove bolt, washer, and retractor from retractor
mounting bracket. Remove seatbelt assembly from lower
B-pillar trim.
11. Remove bolts, washers, and retractor mounting bracket
from B-pillar.
12. Remove bolts, washers, and bracket from B-pillar and
body.
B-PILLAR
BRACKET
BODY
RETRACTOR
MOUNTING
BRACKET
ANCHOR
BRACKET
®