Hummer H1 Service Manual page 875

12-102 Electrical System
POWER DOOR LOCK SWITCH REPLACEMENT
NOTE: Switch replacement is the same for all doors.
Removal
1. Remove mounting plate, capscrews, and remove switch
from switch bezel (Figure 12-102).
2. Disconnect door harness from switch.
Separate switch from mounting plate.
Installation
1. Assemble switch and mounting plate.
2. Connect switch to door harness.
3. Install switch and mounting plate on bezel and secure with
screws.
DOOR
HARNESS
Figure 12-102: Power Door Lock Switch Mounting
4-1-00
______________________________________________________
POWER DOOR LOCK ACTUATOR
REPLACEMENT
Removal
NOTE: Actuator replacement is the same for all doors.
1. Raise window.
2. Remove door trim panel.
3. Remove vapor barrier (Figure 12-103).
SWITCH
BEZEL
Figure 12-103: Vapor Barrier Removal/Installation
4. Detach door harness connector from door actuator
(Figure 12-104).
SWITCH
®
VAPOR
BARRIER