Hummer H1 Service Manual page 894

Section 12 Electrical System
_____________________________________________________
®
POWER DOOR LOCK REAR DOOR AND
JUMPER HARNESS REPLACEMENT
Removal
NOTE: Left and right rear power door locks harness replace-
ment procedures are identical.
1. Remove front seat.
2. Remove trim from B-beam and B-pillar (Section 10).
3. Remove side trim and outer kick panel (Section 10).
4. Remove rear door trim (Section 10).
NOTE: Vapor barrier may be positioned under velcro strip If
so, cut around velcro strip to remove vapor barrier.
5. Remove vapor barrier and moisture barrier flap.
6. Remove capscrew and clamp securing rear door harness to
door reinforcement.
7. Disconnect rear door harness from jumper harness.
8. Remove convoluted tubing from rear door harness.
A-PILLAR
05745159
9.
10. Remove capscrew, washer, nut and lockwasher assembly,
11. Pull harness through rubber grommet in B-pillar.
12. Remove and inspect grommet. Discard if damaged.
13. Remove two capscrews and support bracket from rear
14. Pull harness through door bushing and remove support
15. Inspect bushing in rear door. Replace if damaged.
16. Disconnect door harness connector from actuator lead.
17. Disconnect clip from door reinforcement and remove from
18. Remove rear harness from door.
19. Disconnect jumper harness from dash harness at A-pillar.
Figure 2-116: Door Harness Connection
Electrical System
Remove two-lead connector from rear door harness with
pin extraction tool.
and P-clamp from rear door harness and B-pillar.
door.
bracket from harness. Inspect support bracket bushing.
Replace if damaged.
rear door harness.
Remove tie straps and jumper harness (Figure 2-116).
POWER WINDOWS AND LOCKS
CROSS BODY HARNESS
JUMPER HARNESS
12-121
4-1-00