Hummer H1 Service Manual page 372

___________________________________________
®
THRUST
WASHERS (6)
SHORT
PINION (3)
THRUST
WASHERS (6)
SPROCKET
GEAR
MAINSHAFT
GEAR
FRONT
CASE
Figure 5-141: Differential Pinion and Sprocket Gear
Installation
Figure 5-142: Assembling Differential Front/Rear
05745159
LONG
PINION (3)
REAR
CASE
FRONT
CASE
CASE
ALIGNMENT
MARKS
Cases
Transmission/Transfer Case
NEEDLE ROLLER
BEARINGS
(HOLD IN PLACE
WITH PETROLEUM
JELLY)
Figure 5-143: Mainshaft Bearing Roller Installation
DIFFERENTIAL
Figure 5-144: Installing Differential On Mainshaft
15. Install mode sleeve in mode fork. Replace fork pads if
worn or cracked. Do not reuse worn pads (Figure 5-148).
16. Install assembled mode fork and sleeve on mainshaft.
Then seat sleeve in differential (Figure 5-149).
17. Install assembled mainshaft, differential, mode fork, and
sleeve. Be sure mainshaft is seated in input gear pilot
bearing and that mode fork pin is seated in upper slot of
shift sector as shown (Figure 5-152).
5-173
BEARING
SPACERS
MAINSHAFT