Hummer H1 Service Manual page 1014

______________________________________________________________
®
3. Secure brush assembly power stud to motor housing with
insulator, washer, lockwasher, and nut.
4. Coat armature shaft with lubricant and install in brush
assembly.
5. Coat head of electric thermal switch with lubricant and
connect to two electric
(Figure 13-23).
6. Position spacer in drum support, and install rear cover on
motor housing.
7. Install motor on drum support ensuring to engage motor
shaft into brake drum.
8. Secure motor to motor end drum support with two bolt
assemblies. Tighten hex-head bolt to 60-70 lb-in. (7-8
N•m) (Figure 13-25).
MOTOR
MOTOR END
DRUM SUPPORT
Figure 13-25: Control Unit and Motor
9. Install clamps on motor.
10. Install control on motor.
11. Connect three control leads to terminals and secure with
nuts (Figure 13-21).
12. Secure control to motor with clamps.
13. Install winch assembly and winch cable.
05745159
thermal switch leads
CONTROL
00-S13-008
CLAMP
Winch Roller Fairlead (Option)
Replacement
The winch roller fairlead provides greater functional versatil-
ity. The winch cable can be routed at much sharper angles
since the fairlead rollers will keep it from binding on the
bumper edges.
Removal
WARNING: To avoid injury or damage, support winch
during removal.
1. Remove circlips on one vertical and one horizontal roller.
2. Remove one vertical and one horizontal roller.
3. Remove washers, bolts, and the roller fairlead from the
front bumper (Figure 13-26).
FAIRLEAD
WASHER
Figure 13-26: Winch Fairlead
Installation
1. Place the winch cable and hook assembly through the
roller fairlead and install the fairlead on the front bumper
with washers and bolts. Tighten bolts to 60 lb-ft (81 N•m)
(Figure 13-26).
2. Install the horizontal and vertical rollers and circlips.
Accessories 13-9
FRONT
BUMPER