Hood Prop Rod And Bracket Replacement - Hummer H1 Service Manual

_____________________________________________________________________
®
6. Remove two nut and lockwasher assemblies, screws, cable
clamp bracket, and spacer from bracket assembly.
7. Inspect three nylon bushings in bracket assembly. Remove
and discard bushings if damaged.
PROP ROD
Figure 10-78: Hood Release Latch and
Bracket Assembly Mounting
SPRING
PIN
Figure 10-79: Latch Assembly Breakdown
05745159
HOOD
LATCH
ASSEMBLY
LOCK ARM
LATCH
ASSEMBLY
NUT AND
BRACKET
LOCKWASHER
ASSEMBLY
ASSEMBLY
Figure 10-80: Cable Clamp Bracket Assembly
Breakdown
Installation
1. Insert three nylon bushings into bracket assembly, if
removed (Figure 10-80).
2. Secure spacer and cable clamp bracket to bracket
assembly with two screws and nut and lockwasher
assemblies.
3. Secure bracket assembly to body with three bolts,
lockwashers, and nuts.
4. Secure cable assembly
(Figure 10-77). Seal grommet with silicone sealer.
5. Secure spring and lock arm to latch assembly with pin
(Figure 10-79).
6. Secure latch assembly to hood with two lockwashers and
bolts (Figure 10-78).
7. Lower hood.

Hood Prop Rod and Bracket Replacement

Removal
WARNING: To avoid injury or damage to equipment,
support hood during hood prop rod and bracket re-
placement.
1. Raise and support hood.
2. Remove cotter pin, two washers, and hood prop rod from
hood (Figure 10-81).
3. Remove four screws, lockwashers, bracket, and hood prop
rod from airlift bracket (Figure 10-82).
Body 10-45
CABLE CLAMP
BRACKET
SPACER
CABLE
ASSEMBLY
9-S10-002
BODY
to cable clamp bracket