Hummer H1 Service Manual page 376

___________________________________________
®
30. Position pump assembly in rear case. Be sure pickup
screen is seated in case notch as shown (Figure 5-160).
SNAP RING
Figure 5-155: Front Output Shaft and Sprocket
Assembly
FRONT OUTPUT
SHAFT AND
DRIVEN SPROCKET
CHAIN
Figure 5-156: Drive Chain and Sprocket Installation
05745159
DRIVEN SPROCKET
FRONT OUTPUT SHAFT
DRIVE
SPROCKET
DRIVE
Transmission/Transfer Case
DRIVE
SPROCKET
Figure 5-157: Securing Drive Sprocket to Mainshaft
31. Install magnet in front case pocket (Figure 5-161).
32. Apply 3/16 in. (5 mm) wide bead of Permatex Ultra Black
to sealing flange of front case. Be sure sealer encircles
each case bolt hole.
33. Align and install rear case on front case (Figure 5-162). Be
sure alignment dowel is seated and that oil pump is
properly engaged in mainshaft splines. Also be sure front
output shaft is seated in rear bearing and shift rail is seated
in rear case bore.
34. Install and tighten case bolts in diagonal pattern to 20-25
lb-ft (27-34 N•m).
5-177
DRIVE
SPROCKET
SNAP RING
4-1-00