Hummer H1 Service Manual page 582

________________________________________
®
FRONT BUMPER AND TOWING BRACKETS
REPLACEMENT (VEHICLES WITHOUT WINCH)
Removal
1. Remove brushguard, if equipped.
2. Remove four locknuts, washers, bolts, washers, two
towing brackets, and front bumper from mounting
brackets (Figure 9-115).
Installation
1. Install front bumper and two towing brackets on mounting
brackets with four washers, bolts, washers, and locknuts.
Tighten bolts to 90 lb-ft (122 N•m) (Figure 9-115).
2. Install brushguard, if removed (Section 10).
FRONT BUMPER
TOWING
BRACKET
Figure 9-115: Front Bumper and Towing Bracket Re-
placement for Vehicles Without Winch
05745159
Axles, Suspension, and Frame
FRONT BUMPER AND TOWING BRACKETS
REPLACEMENT (VEHICLES WITH WINCH)
Removal
WARNING: Winch must be supported prior to per-
forming step 1. Failure to observe this warning could
result in personal injury.
1. Remove four bolts and washers securing winch to front
bumper (Figure 9-116).
2. Remove four locknuts, washers, bolts, washers, and two
towing brackets from front bumper and frame extensions.
Discard locknuts.
3. Remove five locknuts, washers, six bolts, washers, and
front bumper from frame extensions.
Installation
1. Install front bumper on frame extensions with six washers,
bolts, five washers, and locknuts. Tighten bolts to 90 lb-ft
(122 N•m) (Figure 9-116).
2. Install two towing brackets on front bumper and frame
extensions with four washers, bolts, washers, and
locknuts. Tighten bolts to 90 lb-ft (122 N•m).
3. Install four bolts and washers securing front bumper to
winch. Tighten bolts to 60 lb-ft (81 N•m).
MOUNTING
BRACKET
Figure 9-116: Front Bumper and Towing Bracket Re-
FRAME EXTENSION
TOWING BRACKET
placement for Vehicles With Winch
9-45
FRONT
BUMPER