IBM V03 Maintenance Information page 236

Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
Then:
1. Open the top cover and remove the ribbon.
2. Disconnect the ribbon motor cable connector from the logic
board. Note the location of the connector and the cable path
to aid installation.
If the motor is being removed only to access other parts, do
not disconnect the connector.
3. Remove the ribbon motor mounting screws and remove the
ribbon drive motor. Note the type and location of each screw
to aid installation.
4. Remove the retaining clip from the drive shaft, and then lift
the shaft out of the bracket.
5. Lift the left ribbon bracket up and out of the printer.
Chapter 5. Removals, service checks and adjustments
236