IBM V03 Maintenance Information page 111

3. To adjust the first print-line for the front tractor feed, press the Line Feed key. The test will
automatically advance to the front tractor first print-line adjustment after you complete the rear (base)
(see Paper path nomenclature).
4. If you want to advance to the front tractor first print-line adjustment, now, press the Start key. The
procedure to adjust either front- or rear-tractor first print-line is the same.
5. If fanfold paper is not loaded, display:
T&D09 First Printing Line Adjustment Test LOAD PAPER
6. Install fanfold paper in the tractor assembly.
7. Press the Load/Eject key.
8. The following message will be displayed:
T&D09 First Printing Line Adjustment Test FANF. XXXX 0 + RUN -
9. A line of Es will be printed on the first printing line, and then the paper will feed to a position for
viewing. The Es should be completely on the paper. The top of the Es should be approximately 1 mm
(0.04 in.) below the perforation.
10. The following message will be displayed:
T&D09 First Printing Line Adjustment Test PRESS A KEY
11. Press any key to feed the paper back into the printer. The following message will display:
T&D09 First Printing Line Adjustment Test STORE YES ... NO
12. If the first print-line adjustment is correct, press the Line Feed key to store the first print-line position.
If the front tractor is installed, install the paper in the front tractor and repeat the above procedure to
adjust the first print line for that tractor.
13. If the first print-line adjustment is not correct, press the Start key to get the next display.
T&D09 First Printing Line Adjustment Test FANF. XXXX 0 + RUN -
111
Chapter 2. Diagnostics