Carriage Asm - IBM V03 Maintenance Information

Carriage asm.

Sheetmetal
Wear Surface
Rubber Ring
(Discard
if present)
Carriage Belt
Clamp Screw
Carriage
Shaft
Left
Retainer
Support
Shaft
Sheetmetal Wear Surface
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
3. Remove the Printhead.
4. Remove the Automatic forms thickness adjust (AFTA)
assembly.
5. Remove the Paper bail assembly.
Then:
Attention: Use care not to damage the encoder strip.
1. Loosen the carriage belt clamp screws (3) and remove the
belt from the clamp.
Attention: In the next step, look for small sheetmetal wear
surfaces may be present straddling the side frame where the
carriage shaft is resting; they are easily lost.
2. Remove the left carriage shaft screws and retainer.
3. Remove the carriage and shaft.
Chapter 5. Removals, service checks and adjustments
211