Reference Table 4, Operator Panel And Miscellaneous Problems - IBM V03 Maintenance Information

Print quality failures (darkness, location, quality)
Vertical print line misalignment (lines move upward,
page-to-page).

Reference table 4, operator panel and miscellaneous problems

Description of Failure
When Menu is pressed, the operator panel displays RECALL
CUSTOM SET VALUES. You cannot get other configuration
menu selections to display.
Operator panel keys operate OK but display is blank and LEDs
are off.
Operator panel display is blank, LEDs are off, and keys do not
operate.
Buzzer sounds continuously.
Green Ready Attention LED does not turn on when the READY
displays.
Printing stops or slow printing.
Printhead carriage only moves approximately 1 inch.
Printing starts to print 1 line, then printer hangs.
Printhead crashes into left or right side frame, or the margins
shift.
AFTA wheel indications varies on same paper-weight.
Fanfold paper does not load or feed. No paper movement.
Action
1. Install a new upper feed roller.
2. Install a new paper bail assembly.
Action
This means the menu is locked. For more detail, see the
Message/Description/Action information for message 097 in the
table for Reference table 1, error messages.
Install a new operator panel (see Operator panel).
1. Ensure that the operator panel cable is connected correctly at
both ends.
2. See MAP 0150: Power supply.
3. Install a new operator panel (see Operator panel).
Install a new logic board (see page Logic board).
Install a new operator panel.
Replace the Ready Attention LED.
See MAP 0140: Printhead drive.
See MAP 0140: Printhead drive.
See MAP 0140: Printhead drive.
See MAP 0140: Printhead drive.
See Standard AFTA service check and adjustment.
See MAP 0130: No paper movement.
Chapter 1. Diagnosing problems
87