Tear-Off Line; Service Check; Adjustment - IBM V03 Maintenance Information

b. While holding the paper in place, advance the forms by hand cycling the upper feed roller.
c. Ensure the sensor is positioned so the LED light passes through the tractor holes.
d. If adjustment is indicated, loosen and retighten the sensor.
e. If adjusting the sensor does not correct the condition, replace the tractor assembly.

Tear-off line

Use T&D11 to adjust the tear-off line, using the operator panel.

Service check

1. Load forms into the tractors.
2. Press Load, Form Feed, then Eject/Tear. This advances the forms to the tear position.
3. Compare the alignment of the perforations on the forms to the tear edge of the printer cover. Perform the
Adjustment, if indicated.

Adjustment

1. Run the T&D program in single test mode (see Running the test and diagnostic (T&D) programs).
2. Scroll to T&D11.
Chapter 5. Removals, service checks and adjustments
185